DAQ-Card 6062E calibration from Luc Lefebvre on 2003-04-24 (gmane.linux.comedi)

From: Luc Lefebvre <luc.lefebvre_at_mcgill.ca>
Date: Thu, 24 Apr 2003 11:03:08 -0400 (EDT)

Hi,

I can interact with my DAQ-Card 6062E using comedi but the calibration 
<comedi_calibrate states that the card is not supported yet...> appears to 
be off.  The voltages read are approx 200 mV off.  Yet when I look at the 
same voltages using the National Instruments Explorer application the 
voltages read are bang on.  I would *much rather* do my data acquisition 
under linux than NT, but I need to have a good calibration.  Any 
suggestions as to how I might go about this would be appreciated.

cheers

-- 
Luc Lefebvre

In the beginner's mind there are many possibilities,
in the expert's mind there are few.			<Shunryu Suzuki>

Key fingerprint = D2E5 5E35 B910 6F4E 0242  EC63 0FD9 96D0 C7F4 784E

Received on 2003-04-24Z14:03:08