NI ATMIO-16E-10 Board..

Hi all... I got the new comedi and was trying to get the ni_atmio driver
to work with it.  I see that it tries to use kernel isa support for the
boards, however this driver has trouble seeing my board for some reason.

I looked at the sources to ni_atmio.c and I don't understand what the
problem could be.  My kernel see the NI-ATMIO-16E-10 device that I have..
here is output from /proc/isapnp:

Card 1 'NIC2400:National Instruments, AT-MIO-16E-10' PnP version 1.0
  Logical device 0 'NIC2400:Unknown'
    Supported registers 0x2
    Device is not active
    Active port 0x100
    Active IRQ 5 [0x2]
    Active DMA 5,6
    Resources 0
      Priority acceptable
      Port 0x20-0xffe0, align 0x1f, size 0x20, 16-bit address decoding
      IRQ 3,4,5,7,10,11,12,15 High-Edge
      DMA 5,6,7 16-bit word-count compatible
      DMA 5,6,7 16-bit word-count compatible
      Alternate resources 0:1
        Priority acceptable
        Port 0x20-0xffe0, align 0x1f, size 0x20, 16-bit address decoding
        IRQ 3,4,5,7,10,11,12,15 High-Edge
        DMA 5,6,7 16-bit word-count compatible
      Alternate resources 0:2
        Priority acceptable
        Port 0x20-0xffe0, align 0x1f, size 0x20, 16-bit address decoding
        IRQ 3,4,5,7,10,11,12,15 High-Edge
      Alternate resources 0:3
        Priority acceptable
        Port 0x20-0xffe0, align 0x1f, size 0x20, 16-bit address decoding
        IRQ <none> High-Edge
  Logical device 1 'NIC2400:Unknown'
    Device is not active
    Resources 0
      Priority acceptable
      DMA 5,6,7 16-bit word-count compatible
      Alternate resources 0:1
        Priority acceptable
        DMA <none> 16-bit word-count compatible


I _did_ notice that the driver has an #ifdef __ISAPNP__ that might be the
culprit.  Where does this get defined?  My kernel's config has all isapnp
turned on, so comedi might have a problem in the build system..


Any ideas?

-Calin

Received on 2003-09-24Z17:03:00