Re: usbdux

From: Bernd Porr <BerndPorr_at_f2s.com> · Date: Thu, 10 Feb 2005 13:24:37 +0000

Hej Per,

It might be just a mismatch between the kernel modules from the original 
kernel and comedi. I would compile the kernel again, reboot and then do 
a fresh installation of comedi.

/Bernd
P.S.: Great to see that it works with Kylix.

www:    http://www.berndporr.me.uk/
         http://www.linux-usb-daq.co.uk/
Mobile: +44 (0)7840 340069
Work:   +44 (0)141 330 5237
         University of Glasgow
         Department of Electronics & Electrical Engineering
         Room 519, Rankine Building, Oakfield Avenue,
         Glasgow, G12 8LT

Per Arlock wrote:
> Hi all,
> 
> I am testing the usbdux-box and the output-lines.
> 
> For example the box outputs waveforms with the demo: ao_waveform as well as a program which was in part copied from that program and implemented in pascal which runs fine in Kylix.
> I have run that on two machines but on the third it does not run. And I need it to run on that machine.
> Issuing modprobe usbdux is no problem but when
> doing comedi_config -i  ...........hex /dev/comedi0 usbdux
> the answer is : comedi.o not loaded.
> But inspecting the list of modules with lsmod it is said that comedi is used by usbdux.
> I also removed ehci_hcd but that did not work either.
> Usbdux is plugged in and the last 6 lines in dmesg are:
> comedi: no version for "struct_module" found: kernel tainted
> comedi: ver 0.7.69 .. David..
> usbdux.c: v1..Sterling.. Bernd.Porr
> comedi_:usbdux: setting all possible devs to invalid
> usbcore: registered new driver usbdux
> 
> Could someone help with this?
> 
> Regards!
> 
> Per Arlock
> Karolinska Inst
> Sweden
> 
> 
> 
> _______________________________________________
> comedi mailing list
> comedi_at_comedi.org
> https://cvs.comedi.org/cgi-bin/mailman/listinfo/comedi