Re: Driver not found

>From: Ian Abbott <abbotti_at_mev.co.uk>
>To: comedi_at_comedi.org
>Subject: Re: Driver not found
>Date: Wed, 23 Feb 2005 11:39:10 +0000
>
>On 23/02/05 09:37, Stefano Gafforelli wrote:
>>>
>>>There aren't many clues there, but based on the error you reported 
>>>earlier (Configure failed!: Input/output error), it looks like the card 
>>>was not detected for some reason.
>>>
>>>You could try loading the comedi module with the debug=1 option to get 
>>>more debugging information when you run 'dmesg'.
>>
>>Hi,
>>what do you mean with debug=1?
>>We try to compile the kernel with "COMEDI verbose debug option".
>
>My mistake.  That should have been "comedi_debug=1".
>
>If you have compiled with the Comedi modules with the "COMEDI verbose debug 
>option" (actually, it might not compile without that option!), there should 
>be a module parameter called "comedi_debug".  You can unload all Comedi 
>modules and reload the "comedi" module as follows:
>
>   modprobe comedi comedi_debug=1
>
>then reload the other modules.
>
>>Using dmesg we obtain:
>>
>>Mounted devfs on /dev
>>Freeing init memory: 104K
>>Linux Kernel Card Services
>>  options:  [pm]
>>IRQ103 (GPIO80): no edges
>>IRQ103 (GPIO80): rising edges
>>IRQ103 (GPIO80): rising falling edges
>>IRQ27 (GPIO4): rising edges
>>eth0: using half-duplex 10Base-T (RJ-45)
>>comedi: version 0.7.67.1 - David Schleef <ds_at_schleef.org>
>>
>>and when we try to configure our pcmcia NI6062E with:
>>"arm-linux-comedi_config /dev/comedi0 ni_mio_cs" we have no changes from 
>>yesterday.
>>
>>The modules we are loaded : comedi.ko comedi_fc.ko 8255.ko ni_mio_cs.ko 
>>(must we load module mite.ko so?)
>
>If you do "modprobe ni_mio_cs" it should automatically load all the modules 
>it depends on, if they are not already loaded.  If you have previously 
>loaded the comedi module with comedi_debug=1, you should get some 
>additional messages when you run dmesg after running 
>arm-linux-comedi_config.

we have just made it an dmesg shows:

Linux Kernel Card Services
  options:  [pm]
IRQ103 (GPIO80): no edges
IRQ103 (GPIO80): rising edges
IRQ103 (GPIO80): rising falling edges
IRQ27 (GPIO4): rising edges
eth0: using half-duplex 10Base-T (RJ-45)
comedi: version 0.7.67.1 - David Schleef <ds_at_schleef.org>
comedi: mio_cs_attach(dev=c0c3b000,it=c06c1ec0)

Luca & Ste.

_________________________________________________________________
Ricerche online pių semplici e veloci con MSN Toolbar! 
http://toolbar.msn.it/ č GRATIS!

Received on 2005-02-23Z12:00:15