[NI PCI-6071E] AI Start Trig

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi All,

I am currently using a National Instruments PCI-6071E to run some experiments. 
I need to ascertain the delay in my code between a signal being sent to an 
external circuit and the start of a round of streamed analogue capturing 
using a command.

I have been informed that it may be possible to get the card to pulse a line 
when it starts the capture process. I can then use this to measure the time 
between the two activites on an oscilloscope. From the documentation I have I 
believe this to be the "PFI 0/AI START TRIG" signal. This line doesn't seem 
to be outputting anything, I guess it is setup as input by default.

Is this the correct line?

How can I set the line up as output?

Thanks in advance,

Martyn

- -- 
Martyn Welch (welchm_at_comp.lancs.ac.uk)

PGP Key : http://ubicomp.lancs.ac.uk/~martyn/pgpkey/
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)

iD8DBQFC5mdrQPzYXciChNcRAja/AJ9UFr9lDQK1KZ8vx0gJj67EbQPjYACgo1fO
zHebdzELsBHPk+z2bnt3LlQ=
=48Id
-----END PGP SIGNATURE-----

Received on 2005-07-26Z15:40:09