NI 6229 driver

Has anyone out there done any work to try to get the ni_pcimio driver to
work with the 6229 board?

So far I have added the ability to use the static DIO channels.  But
right now, I have hit a road block trying to get the Analog In to work.
I am using the DDK from NI as a guide, but with not a whole lot of
luck.  I am just trying to get a single static read to work.  I set up
the board to do a single read into the FIFO, but the status 2 register
never indicates that a scan starts.  It falls through and reads the AI
FIFO data register and the same value is read every time.

If anyone is interested in reviewing my code, I'll be happy to send it 
to you. I attempted to attach them to this message, but I guess it was 
too big  - it didn't seem to make it to the list.

Thanks,

Steve

Received on 2006-06-21Z18:27:40