- From: Steven Hartmann <shartmann_at_militho.com>
- Date: Fri, 30 Jun 2006 08:48:02 -0500
Frank, I'll send the files to you in a separate email - I tried to send it to the group once and I guess it was rejected because of the attachments. We could go ahead and apply the dio part now I suppose - It's in the same source files as I have been trying to get the ai stuff to work, so there are a bunch of printk's I need to clean up before we could really check it in. I've gotten a little further on the AI stuff, but still not working properly. The fifo seems to appear that it is working, in that it shows that an a2d conversion is occuring (AI_Scan_In_Progress_St goes high, then goes low), but when I read the fifo data register, it is always 0x7fff. Steve Frank Mori Hess wrote: > On Wednesday 21 June 2006 03:27 pm, Steven Hartmann wrote: > >> Has anyone out there done any work to try to get the ni_pcimio driver to >> work with the 6229 board? >> >> So far I have added the ability to use the static DIO channels. But >> right now, I have hit a road block trying to get the Analog In to work. >> I am using the DDK from NI as a guide, but with not a whole lot of >> luck. I am just trying to get a single static read to work. I set up >> the board to do a single read into the FIFO, but the status 2 register >> never indicates that a scan starts. It falls through and reads the AI >> FIFO data register and the same value is read every time. >> >> If anyone is interested in reviewing my code, I'll be happy to send it >> to you. I attempted to attach them to this message, but I guess it was >> too big - it didn't seem to make it to the list. >> > > I'd like to see the patch. Is there any reason the dio part can't be > applied now? > >
Received on 2006-06-30Z12:48:02