Re: comedi_calibrate configure failure

On Friday 14 September 2007 10:28, Alessandro Toso wrote:
> Hi Arno,
>
> thank you so much, that was the problem! Now that I was able to
> configure and compile comedi_calibrate, I'm able to to calibrate my
> 6733 output board, but no way to get the calibration for the 6143
> input board:
>
> 1) the comedi_calibrate gives:
>
> init_setup() failed for pci-6143


> Any suggestion?
> Thanks
> Alessandro Toso

comedi_calibrate doesn't support the 6143.  You could try adding an entry 
for it to the boards[] array in comedi_calibrate/ni.c, assuming it works 
like an e-series boards as far as calibration goes.  I really have no idea 
if actually does though.

-- 
Frank