Re: Analog output cb_pcidas and das-1602/16 board

From: Ivan Martinez <imr_at_oersted.dtu.dk> · Date: Fri, 24 May 2002 14:46:28 +0200

"6 channel version of this board"???. You posted about a DDA06/16, which I 
can't find in the list of supported hardware. Which driver are you using?.
Ivan

On Friday 24 May 2002 02:29 pm, Curry, Timothy E  (Contractor-CRC) wrote:
> Calin,
> 	I tried the 6 channel version of this board and I was unsuccessful.
> You can see from my message I sent out yesterday that I can communicate
> with the board but it always goes to -5VDC when I command it. I am not
> experienced enough with device drivers to figure out what is wrong. I hope
> that someone on this reflector will see this message and look into this
> problem for us.
>
> I will let everyone know the solution when I find one.
>
> Tim Curry
>
> > >-----Original Message-----
> > >From: Calin A. Culianu [mailto:calin_at_ajvar.org]
> > >Sent: Thursday, May 23, 2002 3:44 PM
> > >To: comedi_at_stm.lbl.gov
> > >Subject: Analog output cb_pcidas and das-1602/16 board
> > >
> > >
> > >
> > >Unfortunately I have yet to get a breakout box capable of
> > >analog output...
> > >but I was just curious, has anyone tested AO on this board
> > >with the above
> > >driver?
> > >
> > >I was reading the sourcecode to the analog output stuff and
> > >it seems to be
> > >following the register specs for the board to the letter, so
> > >in theory
> > >it should work.. but I was curious if anyone has actually tested it.
> > >
> > >Thanks,
> > >
> > >-Calin
> > >
> > >
> > >
> > >_______________________________________________
> > >comedi mailing list
> > >comedi_at_stm.lbl.gov
> > >http://stm.lbl.gov/cgi-bin/mailman/listinfo/comedi
>
> _______________________________________________
> comedi mailing list
> comedi_at_stm.lbl.gov
> http://stm.lbl.gov/cgi-bin/mailman/listinfo/comedi