RE: Analog output cb_pcidas and das-1602/16 board

From: Curry, Timothy E (Contractor-CRC) <"Curry,> · Date: Fri, 24 May 2002 07:29:22 -0500

Calin,
	I tried the 6 channel version of this board and I was unsuccessful.
You can see from my message I sent out yesterday that I can communicate with
the board but it always goes to -5VDC when I command it. I am not
experienced enough with device drivers to figure out what is wrong. I hope
that someone on this reflector will see this message and look into this
problem for us. 

I will let everyone know the solution when I find one.

Tim Curry

> >-----Original Message-----
> >From: Calin A. Culianu [mailto:calin_at_ajvar.org]
> >Sent: Thursday, May 23, 2002 3:44 PM
> >To: comedi_at_stm.lbl.gov
> >Subject: Analog output cb_pcidas and das-1602/16 board
> >
> >
> >
> >Unfortunately I have yet to get a breakout box capable of 
> >analog output...
> >but I was just curious, has anyone tested AO on this board 
> >with the above
> >driver?
> >
> >I was reading the sourcecode to the analog output stuff and 
> >it seems to be
> >following the register specs for the board to the letter, so 
> >in theory
> >it should work.. but I was curious if anyone has actually tested it.
> >
> >Thanks,
> >
> >-Calin
> >
> >
> >
> >_______________________________________________
> >comedi mailing list
> >comedi_at_stm.lbl.gov
> >http://stm.lbl.gov/cgi-bin/mailman/listinfo/comedi
> >