RE: Analog output cb_pcidas and das-1602/16 board

I am using the cb_pcidda.o driver. The comedi documentation section 5.7
states that the 2 and 8 channels should work and I assumed that the 6
channel should work, too. It is my understanding that the 6 channel version
of this board is relatively new. I have the board specification if you need
them or you can go to www.measurementcomputing.com and download the specs
from their documentation section. 

Is my assumption correct?

> >-----Original Message-----
> >From: Ivan Martinez [mailto:imr_at_oersted.dtu.dk]
> >Sent: Friday, May 24, 2002 7:46 AM
> >To: Curry, Timothy E (Contractor-CRC); 'Calin A. Culianu';
> >comedi_at_stm.lbl.gov
> >Subject: Re: Analog output cb_pcidas and das-1602/16 board
> >
> >
> >"6 channel version of this board"???. You posted about a 
> >DDA06/16, which I 
> >can't find in the list of supported hardware. Which driver 
> >are you using?.
> >Ivan
> >
> >On Friday 24 May 2002 02:29 pm, Curry, Timothy E  
> >(Contractor-CRC) wrote:
> >> Calin,
> >> 	I tried the 6 channel version of this board and I was 
> >unsuccessful.
> >> You can see from my message I sent out yesterday that I 
> >can communicate
> >> with the board but it always goes to -5VDC when I command 
> >it. I am not
> >> experienced enough with device drivers to figure out what 
> >is wrong. I hope
> >> that someone on this reflector will see this message and 
> >look into this
> >> problem for us.
> >>
> >> I will let everyone know the solution when I find one.
> >>
> >> Tim Curry
> >>
> >> > >-----Original Message-----
> >> > >From: Calin A. Culianu [mailto:calin_at_ajvar.org]
> >> > >Sent: Thursday, May 23, 2002 3:44 PM
> >> > >To: comedi_at_stm.lbl.gov
> >> > >Subject: Analog output cb_pcidas and das-1602/16 board
> >> > >
> >> > >
> >> > >
> >> > >Unfortunately I have yet to get a breakout box capable of
> >> > >analog output...
> >> > >but I was just curious, has anyone tested AO on this board
> >> > >with the above
> >> > >driver?
> >> > >
> >> > >I was reading the sourcecode to the analog output stuff and
> >> > >it seems to be
> >> > >following the register specs for the board to the letter, so
> >> > >in theory
> >> > >it should work.. but I was curious if anyone has 
> >actually tested it.
> >> > >
> >> > >Thanks,
> >> > >
> >> > >-Calin
> >> > >
> >> > >
> >> > >
> >> > >_______________________________________________
> >> > >comedi mailing list
> >> > >comedi_at_stm.lbl.gov
> >> > >http://stm.lbl.gov/cgi-bin/mailman/listinfo/comedi
> >>
> >> _______________________________________________
> >> comedi mailing list
> >> comedi_at_stm.lbl.gov
> >> http://stm.lbl.gov/cgi-bin/mailman/listinfo/comedi
> >

Received on 2002-05-24Z11:52:05