RE: Help! - error when "comedi_config"

Hi,

Thanks for reply.

I did load the driver. I doubt there are any errors except the message "... will taint the kernel" which is normal I think.

Btw, I checked with "cat /proc/comedi" (refer to below) doesn’t it shows the driver loaded already?

regards,
Waiyong

-----Original Message-----
From: Xiaomei Niu [mailto:xiaomei_at_cyllene.uwa.edu.au] 
Sent: 2004年8月13日 10:25
To: Sim Wai Yong
Subject: Re: Help! - error when "comedi_config"

Have you loaded the driver (with command /sbin/insmod or /sbin/modprobe 
manually or autonatically) before you do "comedi_config /dev/comedi0 
ni_labpc_cs"?
Is there any error when you load the driver?

Sim Wai Yong wrote:

> Hi,
>
> I am trying to setup my National Instrument Daq card (Daq PCI-1200) in 
> Linux 7.3. Kernel 2.4.18-rtl3.2-pre1.
>
> When I use “comedi_config /dev/comedi0 ni_labpc_cs”
>
> I get these errors:
>
> Configure failed!: Input/output error
>
> Check kernel log for more information
>
> Possible reasons for failure:
>
> Driver not found
>
> I check with “cat /proc/comedi”
>
> I got the message:
>
> Comedi version 0.7.68
>
> Format string: “%2d: %-20s %4d”,I,driver_name,board_name,n_subdevices
>
> No devices
>
> Ni_labpc_cs:
>
> Daqcard-1200
>
> Ni_labpc_cs
>
> Ni_labpc:
>
> Lab-pc-1200
>
> Lab-pc-1200ai
>
> Lab-pc+
>
> Pci-1200
>
> 8255:
>
> 8255
>
> Anyone can help? Thanks in advance…
>
> regards,
>
> Waiyong
>

Received on 2004-08-13Z01:51:19