Re: Gentoo Installation - ID10T Error!

I had issues with this daqcard being improperly named in the driver and 
it throwing the cardbus scripts comedi installs off.  You can either try 
and fix the cardbus script (I am attaching my cardbus script hack) in 
/etc/pcmcia/comedi, or try using the latest (cvs?) version of comedi which 
has this bug fixed.

Attached is my hacked /etc/pcmcia/comedi.

-Calin

On Sat, 26 Nov 2005, Duane Hill wrote:

> I am having some issues with getting Comedi installed.  I am having the
> same problem on both my Gentoo machines so it must be a
> configuration/installation issue.  It could also be an ID 10 T error!
>
> Right now I am using a 2.6.12.5 vanilla kernel.  I checked the latest
> CVS versions of comedi and comedilib last night.  Both compiled just
> fine.  I need to fine tune the configure options so that installation is
> more correct for the gentoo distro.
>
> I have verified that both my DAQCard-DIO-24 and DAQCard-6062E work in
> windows.  The PCMCIA bridge is functioning since my PCMCIA-232/2 works
> as does my Enterasys orinoco based wireless card.  However I only get th
> e low beep tone when I install the 6062E.  If memory serves me
> correctly, this occurs when no driver is loaded.
>
> The modules will install without error but comedi_config /dev/comedi0
> ni_mio_cs returns:
>
> Configure failed!: Input/output error
> Check kernel log for more information
> Possible reasons for failure:
> Driver not found
>
> Any ideas where to start?  Is this a configuration issue from during the compile process?
>
> Thanks,
> Duane
>
>
>
> _______________________________________________
> comedi mailing list
> comedi_at_comedi.org
> https://cvs.comedi.org/cgi-bin/mailman/listinfo/comedi
>