Re: comedi 0.7.70 on CentOS 3.6

On 22/05/06 22:45, Tim Wright wrote:
> I can't figure out how to get by this problem:
> I have the "stock" kernal-source, kernal-unsupported, kernal-hugemem,
> and kernal-smp RPM packages loaded. I'm using a Computerboards DAS-1000,
> and the driver I need is cb_pcidas. I get through the configure make
> make install routine just fine with no errors, but when I try depmod -a
> I get the following:
> [root_at_localhost comedi-0.7.70]# depmod -a depmod:
> *** Unresolved symbols in /lib/modules/2.4.21-37.EL/comedi/cb_das16_cs.o
> depmod: *** Unresolved symbols in
(snip)

> uname -r shows the above (stock for this distro) 2.4.21-37.EL
> Everything I've found to read suggests that it should work by now...
> 
> Please give me a hint as to where I might find the route problem here.
> Thanks tons.	

It's usually down to a .config file mismatch between the running kernel
and the kernel sources that Comedi was built against.  Someone had a
similar problem with RHEL3 a few days back, except that it was
complaining about a kernel module version mismatch when running modprobe
in that case (see
<http://thread.gmane.org/gmane.linux.comedi/4802/focus=4802>).  At least
with CentOS, there is some chance of reproducing the problem without
spending wodges of cash!

-- 
-=( Ian Abbott _at_ MEV Ltd.    E-mail: <abbotti_at_mev.co.uk>        )=-
-=( Tel: +44 (0)161 477 1898   FAX: +44 (0)161 718 3587         )=-

Received on 2006-05-23Z08:24:16