Re: Broken pipe error

From: Steven Hartmann <shartmann_at_militho.com> · Date: Wed, 05 Jul 2006 19:20:42 -0500

M series support is not complete.  I think the 625x cards seem to work 
better than the 622x cards.  You didn't say which you had. 
sphericaline_at_aim.com wrote:
> We are trying to use an external trigger to start a scan on an M Series 
> NiDaq card.
>
> The comedi_get_subdevice_flags function produces "ni_mio_common: ai 
> error a_status = 88b0" and when the read function is reached shortly 
> after, we get a "Broken pipe" error.
>
> We are using 100 kHz square wave into PFI 2.  The scan_begin_src flag 
> is set to TRIG_EXT and scan_begin_arg is set to 2.
>
> Any suggestions or advice would be most appreciated.
>
> Daryl Ng
> ________________________________________________________________________
> Check Out the new free AIM(R) Mail -- 2 GB of storage and 
> industry-leading spam and email virus protection.
>
>
> _______________________________________________
> comedi mailing list
> comedi_at_comedi.org
> https://cvs.comedi.org/cgi-bin/mailman/listinfo/comedi
>