- From: Ian Abbott <abbotti_at_mev.co.uk>
- Date: Wed, 08 Mar 2006 10:26:45 +0000
[Please Cc: comedi_at_comedi.org in replies] On 07/03/06 17:17, Aytac GOREN wrote: > How about pcm3712? I couldn't find the supported driver...pls help... No, it's not supported in the official Comedi drivers. If you have a driver for it from Advantech and it is licensed under the GPL then there is no reason why it can't be incorporated into the official Comedi drivers. Ian. > -----Original Message----- > From: comedi-admin_at_comedi.org [mailto:comedi-admin_at_comedi.org] On Behalf Of > Ian Abbott > Sent: Tuesday, March 07, 2006 5:35 PM > To: comedi_at_comedi.org > Cc: Cloves > Subject: Re: Driver PCM3718 > > On 06/03/06 20:21, Cloves wrote: >> We have bought an ADVANTECH PC-104 card PCM - 3718H, our operational > system is Linux Debian 3.1 - Kernel 2.4.27. >> We have followed the instructions listed in the user-manual.pdf from > advantech. To compile the linux kernel and install comedi device driver. >> We are having problems running comedi driver. >> We issue the following comand lines: >> >> > ---------------------------------------------------------------------------- > --- >> command #1: $ modprobe pcm3718 >> Results: >> comedi: version 0.7.60 - David Schleef >> Warning: loading > /lib/modules/2.4.27/misc/pcm3718.o will tanted the kernel: no license >> Module pcm3718 loaded, with warnings. >> >> command #2: $comedi_config /dev/comedi0 pcm3718 0x300 >> Results: >> ..., I canīt detect board. FAIL! >> Configure failed!: Input/output error >> Check kernel log... >> Possible reasons for failure: >> Driver not found >> > ---------------------------------------------------------------------------- > ----------------------- >> >> >> Would you give us an idea why it doesnīt work? > > I suggest you try a later version of the Comedi drivers from the > www.comedi.org instead of whatever Advantech supply. comedi-0.7.70 > should work on your kernel. The official Comedi drivers do not have a > pcm3718 kernel module, but the pcl818 module supports the PCM-3718H. > > Try: > > modprobe pcl818 > comedi_config /dev/comedi0 pcm3718 0x300 > > Also check the base address 0x300 matches the switches on the board. > -- -=( Ian Abbott _at_ MEV Ltd. E-mail: <abbotti_at_mev.co.uk> )=- -=( Tel: +44 (0)161 477 1898 FAX: +44 (0)161 718 3587 )=-
Received on 2006-03-08Z10:26:45