- From: Ian Abbott <abbotti_at_mev.co.uk>
- Date: Fri, 30 Jun 2006 11:24:03 +0100
On 29/06/2006 14:34, Andrea Davighi wrote: > I'm using an output card Advantech PCL-727 with the driver pcl726, and > graphical interface xrtailab. > I have a problem with I will start the target from shell, because > immediately the board produce a signal of 4,999 Volt continuously also > if I will stop the target. > To eliminate the signal from the board output channel, I have,always, > restart the PC. > I ask if somepeople knows this problem and can help me. I'm having some trouble understanding your English, so I'm not sure what your problem is. The PCL-726 looks like a simple card though, so there isn't much that can go wrong. Make sure the comedi_config command-line parameters that set the range of each channel match the jumper settings on the card. Then when you write 0 to a channel you should get 0V output. -- -=( Ian Abbott _at_ MEV Ltd. E-mail: <abbotti_at_mev.co.uk> )=- -=( Tel: +44 (0)161 477 1898 FAX: +44 (0)161 718 3587 )=-
Received on 2006-06-30Z09:24:03